Adjust the front and back of the vibration, left and right clearance, so that it is in a free state

Water-cement ratio is too small, can not be liquefied after vibration, plate surface is not slurry

Plate surface depression

The small drop between the vibrating plate and the forming scraper causes the plate to crack

Cracks and irregular edges on both sides of the plate

序号 原因分析 排除方法 1 搅刀严重磨损、送料不足 更换搅刀 2 水灰比过大、搅刀沾灰严重 调整水灰比、清理搅刀 3 板厚超标 查明原因、排除超厚现象

The supply voltage is too high or too low. Measure: Add regulator to batching controller.

1、切割机横向行走爬行。 原因：油箱油面低，油缸内有空气。 排除方法：把油箱加满油，把油缸两端油管螺栓松开，启动电机，按左、右开关进行排气。 2、切割机停止工作后刀盘下