Out of control or misoperation during batching

Cause: power supply or surrounding electrical equipment interference. Measures: Turn off the power supply of the batching controller and restart, so that the electric equipment such as electric welding machine can be placed as far away as possible from the batching machine. Reason: The supply voltage is too high or too low. Measure: Add regulator to batching controller. Cause: Overheating of batching controller. measures; increase sun protection facilities for them. 

No weighing 

Cause: 

a. did not remove the fixed bolt between weighing system and rack. Measure: Remove the bolt. 

b. lever system error. Measure: Adjust the lever system. c. sensor drift error. Measure: Recalibrate weighing system. 

d. sensor damaged. Measure: Replace sensor. 

Some material doesn't match 

Reasons: loose motor wiring, lack of phase; strong control part of AC contactor damage.

 Measures: Check the electrical control lines and troubleshoot. 

Ring conveyor belt deviation 

Reason: The main and passive roller axis lines are not parallel. Measure: Adjust the top bolt of tensioning frame. 

Fault of batching controller 

Refer to the relevant provisions of the instructions of the batching controller.