There are many factors that affect the quality of light partition board. Besides production and installation, scientific management in maintenance stage should also not be ignored.Some wall material enterprises in the production can do all the work, there are no technical problems, but because of the maintenance of the product did not form a set of strict and effective management system, resulting in the original qualified products appear problems, this phenomenon must be avoided.

The main measure that says light weight to lie between wall board to maintain below.

1, the storage environment should be appropriate.After the production of lightweight wallboard to experience a period of maintenance period, maintenance period is generally not less than 20 days.The curing stage has certain requirements on the temperature and humidity of the storage environment, which cannot be stored at will.For example, if the storage environment is too low temperature, cement and other slurry is difficult to reach the qualified strength, resulting in the strength of the whole wallboard reduced;If placed in the hot sun, the two sides of the light wall will harden at different rates, causing the surface to bend;In the rainy season, excessive humidity in the region, it is appropriate to extend the maintenance period, so that the light partition wall has enough drying time, and so on.

2. The light wall panels should be put in the correct way.No matter what kind of wallboard products, after the release of paste is often in the initial setting state, at this time the board has a certain strength, but there are still a lot of distance to reach the use of strength, so you must put the wallboard code in the level of the place, otherwise the board easily deformation, affect the flatness.Stacking method is generally adopted. According to different products, each stack can be piled up to 2-3 meters high.For the convenience of shipment in the future, but also in the bottom of the pallet placed in advance, to ensure the quality of the tray itself and the placement of the flatness, to avoid uneven stress and the occurrence of light bending wallboard.

In addition, during the maintenance period, do not move the wallboard frequently to avoid damage of the product caused by external forces. If it is necessary to move and handle, use forklifts, ground cows, stacking machines and other tools as much as possible instead of manual handling.